Technical Data
Press force
630 kN (available from 100 strokes/min)
Stroke rate
stepless up to 500 strokes/min
Distance between table and ram (with clamping bars), largest stroke at the bottom, adjustment at the top
325/370 mm (without ram plate)
Ram adjustment
80 mm
Ram stroke adjustable
8 – 80 mm
Ram surface (L x W)
500 x 293 mm
Ram plate (L x W x H)
620 x 500 x 45 mm
Drilled hole in the ram
Ø 50 x 100 mm
Fitting groove in the ram
30 H7 mm
Table surface (L x W)
950 x 710 mm
Mould dimensions (L x W)
910 x 610 mm
Clamping bars thickness
80 mm
Through-hole clamping bars (L x W)
straight x 130 190 mm (adjustable)
Through-hole in the table (L x W)
640/520 x 200 mm
Belt infeed above clamping surface
feed-dependent
Drive power
22 kW
Weight (without feed)
8000 kg
Dimensions (L x W x H)
1820 x 1240 x 2800 mm
Technical changes reserved.
Structure
- Press body in stable double-column monoblock design made of vibration-damping gray cast iron
- Eccentric shaft on roller bearings with adjustment stroke and rotating mass balance
- Air-cooled piston rod, mounted on the eccentric shaft with multi-row, heavy-duty caged roller bearings
- Press ram made of high-strength titanium alloyed cast Al, 6-fold backlash-free rolling bearing supported by linear roller bearing on hardened and ground guideways
- Press drive via frequency-controlled three-phase motor, flywheel and pneumatic clutch-brake combination
- Press sequence control in PLC technology
- Press control with cam controller, mould and press force monitoring
- Special/additional equipment possible at any time by technical arrangement
- The SEP 63SN-950 stamping press can be individually equipped with gripper or roller feeds pushing or pulling
Dimensions
* Belt infeed height above clamping surface on request (feed-dependent)
** Mould installation height (see table)
*** The lateral passage on the press body is reduced to 260 mm when a gripper feed is used (special widths on request)
Ram Surface
Mould mounting surface
Ram stroke in mm
Mould installation height min.-max.
Permissible stroke rate depending on ram stroke
8
281-361
500
10
280-360
470
16
277-357
380
22
274-354
340
28
271-351
300
35
268-348
260
40
265-345
240
46
262-342
230
52
259-339
220
57
257-337
210
62
254-334
200
66
252-332
195
70
250-330
190
73
249-329
180
75
248-328
180
77
247-327
165
78
246-326
160
79
246-326
150
80
245-325
140
mechanically adjustable
Installation height in mm for bottom ram stroke (BDC) with ram plate (without = plus 45 mm)
with maximum mould upper part weight of 320 kg
Download PDF here:
