Technical Data
Press force
630 kN (available from 100 strokes/min)
Stroke rate
stepless up to 500 strokes/min
Distance between table and ram (with clamping bars), largest stroke at the bottom, adjustment at the top
250/275 mm (without ram plate)
Ram adjustment
80 mm
Ram stroke adjustable
8 – 80 mm
Ram surface (L x W)
500 x 293 mm
Ram plate (L x W x H)
500 x 400 x 25 mm
Drilled hole in the ram
Ø 50 x 100 mm
Fitting groove in the ram
30 H7 mm
Table surface (L x W)
710 x 710 mm
Mould dimensions (L x W)
670 x 610 mm
Clamping bars thickness
80 mm
Through-hole in the clamping plate (L x W)
straight x 130 - 190 mm (adjustable)
Through-hole clamping bars (L x W)
640/520 x 200 mm
Belt infeed above clamping surface
vorschubabhängig
Drive power
22 kW
Weight (without feed)
6200 kg
Dimensions (L x W x H)
1700 x 1240 x 2550 mm
Technical changes reserved.
Structure
- Press body in stable double-column monoblock design made vibration-damping gray cast iron
- Eccentric shaft on roller bearings with adjustment stroke and rotating mass balance
- Air-cooled piston rod, mounted on the eccentrics shaft with multi-row, heavy-duty caged roller bearings
- Press ram made of high-strength titanium alloyed cast Al, 6-fold backlash-free rolling bearing supported by linear roller bearings on hardened and ground guideways
- Press drive via frequency-controlled three-phase motor, flywheel and pneumatic clutch-brake combination
- Press sequence control in PLC technology
- Press control with cam controller, mould and press force monitoring
- Special/additional equipment possible at any time by technical arrangement
- The SEP 63N stamping press can be individually equipped with gripper or roller feeds pushing or pulling
Dimensions
* Belt infeed height above clamping surface on request (feed-dependent)
** Mould installation height (see table)
*** The lateral passage on the press body is reduced to 260 mm when a gripper feed is used (special widths on request)
Ram Surface
Mould mounting surface
Ram stroke in mm
Mould installation height min. – max.
Permissible stroke rate depending on ram stroke
8
206-286
500
10
205-285
480
16
202-282
460
22
199-279
380
28
196-276
340
35
193-273
300
40
190-270
290
46
187-267
270
52
184-264
260
57
182-262
250
62
179-259
240
66
177-257
230
70
175-255
220
73
174-254
210
75
173-253
200
77
172-252
190
78
171-251
180
79
171-251
160
80
170-250
140
mechanically adjustable
Installation height in mm for bottom ram stroke (BDC) with ram plate (without = plus 25 mm)
with maximum mould upper part weight of 120 kg
Download PDF here:
