Technical Data
Press force
400 kN (available from 100 strokes/min)
Stroke rate
stepless up to 500 strokes/min
Distance between table and ram (with clamping plate), largest stroke at the bottom, adjustment at the top
270 mm
Ram adjustment
70 mm
Ram stroke adjustable
8 – 70 mm
Ram surface (L x W)
340 x 320 mm
Drilled hole in the ram
Ø 40 x 80 mm
Fitting groove in the ram
30 H7 mm
Table surface (L x W)
610 x 690 mm
Mould dimensions (L x W)
570 x 590 mm
Clamping plate thickness
60 mm
Through-hole in the clamping plate (L x W)
460 x 160 mm
Through-hole in the table (L x W)
540/460 x 200 mm
Belt infeed above clamping surface
feed-dependent
Drive power
18,5 kW
Weight (without feed)
5400 kg
Dimensions (L x W x H)
1420 x 1140 x 2400 mm
Technical changes reserved.
Structure
- Press body in stable double-column monoblock design made of vibration-damping gray cast iron
- Eccentric shaft on roller bearings with adjustment stroke and rotating mass balance
- Air-cooled piston rod, mounted on the eccentric shaft with multi-row, heavy-duty caged roller bearings
- Press ram made of high-strength titanium alloyed cast Al, 6-fold backlash-free rolling bearing supported by linear roller bearings on hardened and ground guideways
- Press drive via frequence-controlled three-phase motor, flywheel and pneumatic clutch-brake combination
- Press sequence control in PLC technology
- Press control with cam controller, mould and press force monitoring
- Special/additional equipment possible at any time by technical arrangement
- The SEP 40N stamping press can be individually equipped with gripper or roller feeds pushing or pulling
Dimensions
* Belt infeed height above clamping surface on request (feed-dependent)
** Mould installation height (see table)
*** The lateral passage on the press body is reduced to 260 mm when a gripper feed is used (special widths on request)
Ram Surface
Mould mounting surface
Ram stroke in mm
Mould installation height min. – max.
Permissible stroke rate depending on ram stroke
8
231-301
500
10
230-300
480
15
228-298
470
20
225-295
460
25
223-293
420
31
220-290
380
36
217-287
340
41
215-285
320
46
212-282
300
50
210-280
290
54
208-278
280
58
206-276
270
61
205-275
260
64
203-273
240
66
202-272
220
68
201-272
200
69
201-271
190
70
200-270
180
mechanically adjustable
Installation height in mm for bottom ram stroke (BDC)
with maximum mould upper part weight of 60 kg
Download PDF here:
