Technical Data
Press force
250 kN (available from 150 strokes/min)
Stroke rate
stepless up to 500 strokes/min
Distance between table and ram (with clamping plate), largest stroke at the bottom, adjustment at the top
240 mm
Ram adjustment
60 mm
Ram stroke adjustable
8 - 60 mm
Ram surface (L x W)
280 x 260 mm
Drilled hole in the ram
Ø 40 x 80 mm
Fitting groove in the ram
30 H7 mm
Table surface (L x W)
490 x 560 mm
Mould dimensions (L x W)
450 x 460 mm
Clamping plate thickness
50 mm
Through-hole in the clamping plate (L x W)
330 x 120 mm
Through-hole in the table (L x W)
420/340 mm x 160 mm
Belt infeed above clamping surface
feed-dependent
Drive power
11 kW
Weight (without feed)
3400 kg
Dimensions (L x W x H)
1180 x 950 x 2200 mm
Structure
- Press body in stable double-column monoblock design made of vibration-damping gray cast iron
- Eccentric shaft on roller bearing with adjustment stroke and rotating mass balance
- Air-cooled piston rod, mounted on the eccentric shaft with multi-row, heavy-duty caged roller bearings
- Press ram made of high-strength titanium alloyed cast Al, 6-fold backlash-free rolling bearing supported by linear roller bearings on hardened and ground guideways
- Press drive via frequency-controlled three-phase motor, flywheel and pneumatic clutch-brake combination
- Press sequence control in PLC technology
- Press control with cam controller, mould and press force monitoring
- Special/additional equipment possible at any time by technical arrangement
- The SEP 25N stamping press can be individually equipped with gripper or roller feeds pushing or pulling
- In the high-speed version, speeds of up to 800 strokes/min are also possible
Dimensions
* Belt infeed height above clamping surface on request (feed-dependent)
** Mould installation height (see table)
*** The lateral passage on the press body is reduced to 180 mm when a gripper feed is used (special widths on request)
Ram Surface
Modul mounting surface
Ram stroke in mm
Mould installation height min. – max.
Permissible stroke rate depending on ram stroke
8
206-266
500
10
205-265
490
13
204-264
480
17
202-262
470
222
199-259
460
27
198-258
420
32
194-254
380
36
192-252
360
40
190-250
340
44
188-248
330
47
187-247
320
50
185-245
300
53
184-244
290
55
183-243
280
56
182-242
270
58
181-241
260
59
181-241
240
60
180-240
220
mechanically adjustable
Installation height in mm for bottom ram stroke (BDC)
with maximum mould upper part weight of 50 kg
Download PDF here:
