Schaal Technology | Stamping press SEP12 | Schaal Technology

Press force

120 kN (available from 150 strokes/min)

Stroke rate

stepless up to 600 strokes/min

Distance between table and ram (with clamping plate), largest stroke at the bottom, adjustment at the top

215 mm (max.)

Ram adjustment

40 mm

Ram stroke adjustable

8 - 40 mm

Ram surface (L x W)

225 x 140 mm

Drilled hole in the ram

Ø 32 x 60 mm

Fitting groove in the ram

16 H7 mm

Table surface (L x W)

370 x 440 mm

Mould dimensions (L x W)

330 x 340 mm

Clamping plate thickness

50 mm

Through-hole in the clamping plate (L x W)

240 x 120 mm

Through-hole in the table (L x W)

300/240 mm x 160 mm

Belt infeed above clamping surface

feed-dependent

Drive power

5,5 kW

Weight (without feed)

1800 kg

Dimensions (L x W x H)

940 x 740 x 1.900 mm

Technical changes reserved

Press body in stable double-column monoblock design made of vibration-damping gray cast iron
Eccentric shaft on roller bearings with adjustment stroke and rotating mass balance
Air-cooled piston rod, mounted on the eccentric shaft with multi-row, heavy-duty caged roller bearing
Press ram made of high-strength titanium alloyed cast Al, 4-fold backlash-free roller bearings on hardened and ground guideways
Press drive via frequency-controlled three-phase motor, flywheel and pneumatic clutch-brake combination
Press sequence control in PLC technology
Press control with cam controller, mould and press force monitoring
Special/additional equipment possible at any time by technical arrangement
The SEP 12 stamping press can be individually equipped with gripper or roller feeds pushing or pulling
In the high-speed version, speeds of up to 800 strokes/min are also possible

Maße