Technical Data
Press force
1000 kN (available from 100 strokes/min)
Stroke rate
stepless up to 320 strokes/min
Distance between table and ram (with clamping bars), largest stroke at the bottom, adjustment at the top
320 mm
Ram adjustment
100 mm
Ram stroke adjustable
10 – 100 mm
Ram Plate (L x W x H)
800 x 600 x 50 mm
Fitting groove in the ram
30 H7 mm
Table surface (L x W)
1050 x 860 mm
Mould dimensions (L x W)
1.010 x 760 mm
Clamping bars thickness
100 mm
Through-hole clamping bars (L x W)
straight x 100 220 mm (adjustable)
Through-hole in the table (L x W)
840/720 x 260 mm
Belt infeed above clamping surface
feed-dependent
Drive power
22 kW
Weight (without feed)
13000 kg
Dimensions (L x W x H)
2400 x 1550 x 3000 mm
Technical changes reserved.
Structure
- Press body in stable double-column monoblock design made of vibration-damping gray cast iron
- Eccentric shaft on roller bearings with adjustment stroke and rotating mass balance
- Air-cooled piston rod, mounted on the eccentric shaft with multi-row, heavy-duty caged roller bearings
- Press ram made of high-strength titanium alloyed cast Al, 6-fold backlash-free rolling bearing supported by linear roller bearings on hardened and ground guideways
- Press drive via frequency-controlled three-phase motor, flywheel and pneumatic clutch-brake combination and planetary gear
- Press sequence control in PLC technology
- Press control with cam controller, mould and press force monitoring
- Special/additional equipment possible at any time by technical arrangement
- The SEP 100 stamping press can be individually equipped with gripper or roller feeds pushing or pulling
Dimensions
* Belt infeed height above clamping surface on request (feed-dependent)
** Mould installation height (see table)
*** The lateral passage on the press body is reduced to 260 mm when a gripper feed is used (special widths on request)
Ram Surface
Mould mounting surface
Ram stroke in mm
Mould installation height min. – max.
Permissible stroke rate depending on ram stroke
10
265-365
320
13
263-363
315
20
260-360
310
27
256-356
300
35
252-352
270
43
248-348
250
50
245-345
230
58
241-341
215
64
238-338
200
71
234-334
190
77
231-331
185
82
229-329
180
86
227-327
170
90
225-325
155
94
223-323
140
96
222-322
130
99
221-321
115
100
220-320
110
mechanically adjustable
Installation height in mm for bottom ram stroke (BDC) with ram plate (without = plus 50 mm)
with maximum mould upper part weight of 380 kg
Download PDF here:
